|Battery Capacity||3.7V / 45 000mAh /166.5WH|
|Output||5V/1A , 5V/2.1A ---mobile phone, tablet PC, other digital devices 12V/10A ---12V car electronic products 3W LED light 12V Jump Start 24V Jump Start|
|Input||Quick charge (5V/2.4A, 9V/2A, 12V/1.5A)|
|Start Current||1 000A|
|Peak Current||2 000A|
CHARGING XX%Shows up the percentage of being charged when it is connected to power supply
Shows up the amount of internal battery capacity. At least 60% are recommended to jump start a car.
LOW BATTERY RECHARGE NOWIndicates low battery, please recharge.
USB1 USB2 ONUSB port 1 and 2 are available to recharge mobile USB devices
Shows that the clamps are connected reversely. At this time the start is prevented. Please remove the clamps and connect them in the right way. The red clamp must be connected to the positive (+) terminal and the black clamp to the negative (-) terminal of the battery. If you are sure that the connections are correct but this warning still shows up, press the Power button for three seconds to ignore this warning.
SHORT CIRCUIT CHECK ALL CONNECTIONSIt indicates a short circuit. At this time the start is prevented. Please remove the clamps and press the power button for three seconds before reconnecting the clamps to the battery.
12V JUMP START READYShows up when heavy duty jump starter C45 is connected to a 24V battery and is ready to jump start. If C45 cannot detect the battery or the battery is too low to be detected, you may use the “Expert Mode” for manually choosing your 12V battery type and jump start your 12V car battery.
24V JUMP START READY
Shows up when C45 is connected to a 24V battery and is ready to jump start. If C45 cannot detect the battery or the battery is too low to be detected, you may use the “Expert Mode” for manually choosing your 24V battery type and jump start your 24V car battery.
the lumen of led light is 3W, and there are three modes: lighting, strobe, and flashing. Please press the button on the front till 3 or 5 second to see the lighting. If you want to change the any of these mode, you can press it at one time.
* 3 in 1 USB cables
* Home Charger
* Smart jumper cable
1.Make sure the battery is not less than 60% shown on the LCD display.
2.Connect the RED clamp to the vehicle's battery positive (+) terminal and connect the BALCK clamp to the vehicle's battery negative (-) terminal.
3.When you use C45 jump start 12V car, it diaplays"12V JUMP START READY",when you use C45 jump start 24V car,it diaplays"24V JUMP START READY".
4.Start the vehicle.
5.When the vehicle is restarted, please remove the jumper cable from Jump Starter and remove RED and BALCK clamps from the vehicle battery.